share china brand universal chip ic programmer

clone k-tag ecu programmer have updated to V6.070 firmware, do you know how to update old v5.001 k-tag firmware to v6.070, here, vipprogrammer share with the method of updating clone Ktag 5.001 to 6.070,

update file and update instructions of clone ktag ecu programmer, the Solution worked 100%, Test you NXP processor in ktag by do a read, if you can't read it some say you can lock it and then you will have to buy a newone. or your safety read and save all nxp data and sd card before pro

Password will by asked, need contact with us.

china clone KTAG UPDATE KIT

https://mega.co.nz/#!HoFTwJCK!6aSwXv7vpUoFT4JDaXY-y54kWEcsHWRzDH8yjZt-kIM

Clone KTAG UPDATE INSTRUCTIONS

https://mega.co.nz/#!fsFlAb4A!D7mNTsKe5GINLpxWXkO_IgIBXYOFAFj2xAW8jdWWD1A

KESS V2.08

https://mega.co.nz/#!Cp0BmIjI!JEbKUXWjR0yZ1KL9l8mKvFE_h83MwOPIzcXOQgxSFMY

2: Software Version: V2.11

Hardware/Firmware Version: V6.070 No Token Limitation, remove the jlink

KTAG 2.11 FW 6.070

New added features of V2.11 K-suite Ktag V6.070 Firmware

1) One click tokens charge function

New K-tag add one button on the main unit. This button is used to charge tokens. Once your tokens run over, just click this button, then tokens will go back to 30 tokens. You can go on to use it again. No need change new tokens chip, no need desolder and program the tokens chip. More easily than ever.

2) Adds more ECU types and protocols

Since firmware is updated to new version, it can fit 2.11 software perfectly. Almost all ECUs and protocols are opened.